here is how to reduce power on trio 9000

Author Post

Dave, GM6JUA

Fri Jan 22 2010, 04:56PM
TX Power Reduction

1.On Final board (backpanel) lift Connector 1 pin 6 (PC signal) wire and insulated it. This disables the HI/LOW button and forces low power always..This should make step # 2 unnecessary, but I haven't undone it myself yet so I will list it now...
2.Lift RX board Connector 10 pin 4 (SOC) wire and insulated it. This makes SSB mode go to low power from LOW position of HI/LOW. Originally SSB wasn't affected by the HI/LOW button (always full power).
again thanks for all help
Back to top