Circuit for 6m 5 watt linear?

Author Post

Ian, G4JQT

Thu Mar 18 2010, 10:45AM
Hello there!

For some time now I've been looking for a design for a home-brew QRP-ish linear.

I have about 100mW of drive. The most promising circuit so far seems to be the IRF610 linear in RadCom Handbook 10th edition fig 5.26 page 5.12.

I used IRF510 and also IRF513, not the specified IRF610 as these were what I had and spec seemed close enough. But they self-destructed when the drive was removed!

I have looked on this forum searching for 'linear' for some clues, but found nothing.

A solid-state circuit 12 volts is preferred, but anything considered.

Thanks and regards,

Ian, G4JQT

[ Edited Thu Mar 18 2010, 10:45AM ]
Back to top
David, G8LZE
Thu Mar 18 2010, 01:14PM
David, G8LZE
Registered Member #9
Joined: Tue Mar 18 2008, 08:34AM

Posts: 25
Afternoon Ian, Not exactly what you are looking for but: and look interesting.

Also, Spectrum Communications do a range of PA kits for their transverters which may provide the basis of a solution. I suspect the IRFs were destroyed due to self oscillation.
Good luck,
David
G8LZE
Back to top
Steve, G4WCS
Thu Mar 25 2010, 11:07AM
Steve, G4WCS
Registered Member #283
Joined: Fri Apr 18 2008, 11:55AM

Posts: 70
Ian, Ive a set of PW meon documentation taht covers the construction of a linear- alternatively how about a CB "burner" with the tuned circuits tweaked these can be picked up off ebay for less than the cost of a good RF power transistor
Back to top